Receiver RadioMaster RP1 V2 ELRS 2.4GHz Nano

Opis szczegółowy produktu

RP1 V2 ExpressLRS 2.4ghz Nano Receiver (LBT)

The RP1 2.4GHz ELRS nano receiver is an open-source receiver based on ExpressLRS and features ESP8285 MCU and SX1280 RF chip. The RP1 has a UFL antenna socket for full-range antenna use. It has built-in WIFI and is suitable for many models due to the ultra-light and Nano size. Due to the low-latency and high-refresh-rate RF module, the RP1 is ideal for FPV races or Long Range. 

Note: Available with standard ISM or EU LBT FW. EU LBT FW is required for use with Radios and Modules with EU LBT FW Installed.

Features:
- Improved PCB design is better for heat dissipation.
- Upgraded rigid antenna with greater durability and performance.
- LED on the top side of the PCB.
- Solder pads are improved and easier to solder to.
- Built-in a TCXO (temperature-compensated crystal oscillator)

Specification:
Item: RP1 Nano ExpressLRS 2.4ghz Receiver
Type: EU LBT FW
MCU: EPS8285
RF Chip: SEMTECH SX1281
Telemetry RF power: 10mW
Antenna: 65mm 2.4ghz T Antenna
Frequency Range: 2.404 - 2.479 Ghz
Maximum receive refresh rate: 500Hz / F1000Hz
Minimum receiver refresh rate: 25Hz
Working voltage: 5v
Weight: 2.2g (Including antenna)
Dimension: 13x11x3mm
Firmware Version: ExpressLRS v2.4 pre-installed
FW Target: RadioMaster RP1/2 2400 RX
Bus interface: CRSF