FC SpeedyBee F7 V3

Product detailed description

SpeedyBee F7 V3 Flight Controller

The SpeedyBee F7 V3 Flight Controller is an F722 FC featuring a BMP280 barometer, OSD, 500MB Memory Blackbox, a built-in FC LiPo monitoring system, and many more features. Equipped with solder-free connectivity options.

Features:
-500MB Onboard Blackbox Flash memory
-8 Motor output perfect for X8 Cinelifters
-30.5 x 30.5mm Mounting Pattern
-FC LiPo Monitoring System
-Built-in Barometer
-4 LED Plugs
-F722 FC
-Buzzer

Specifications:
Power Output:
1) 10 groups of 5V output, three +5V pads and 1 BZ+ pad (used for Buzzer) on the front side, and 6 +5V output included in the connectors on the bottom side. The total current load is 2A.
2) 2 groups of 9V output, one +9V pad on the front side and the other included in a connector on the bottom side. The total current load is 4A.
3) Supported. Designed for the receiver and GPS module even when the FC is powered through the USB port. Up to 1A current load Supported. Designed for 3.3V-input receivers. Up to 500mA current load.
WiFi Support, used for data transfer, e.g. firmware flashing, and Blackbox analysis.
I2C: Supported. SDA & SCL pads on the front side. Used for magnetometer, sonar, etc.
Support Flight Controller Firmware: BetaFlight(Default), EMUFlight, INAV
ESC signal M1 - M4 on the bottom side and M5-M8 on the front side.
LED: Used for WS2812 LED controlled by Betaflight firmware.
UART: 5 sets (UART1, UART2, UART3, UART4, UART6)
DJI Air Unit plug: A full DJI Air Unit JST slot onboard
BLE Support, used for Flight Controller configuration
Buzzer: BZ+ and BZ- pad used for 5V Buzzer
Mounting: 30.5x30.5mm, 4mm hole size
Dimensions: 41(L) x 38(W) x 8.1(H)mm
OSD: BetaFlight OSD w/ AT7456E chip
BlackBox: 500MB onboard data flash
BetaFlight Camera Control Pad: Yes
ESC Telemetry: UART UART4 RX
Power input: 3S - 6S Lipo
Target: SPEEDYBEEF7V3
SmartPort: Supported
Baro: BMP280 (I2C)
MCU: STM32F722
Boot button: Yes
RSSI input: Yes
IMU: BMI270
USB: Type-C
Weight: 9g