Receiver RadioMaster RP2 V2 ELRS 2.4GHz Nano
Code: HP0157.RX-RP2-V2-LBTProduct detailed description
RP2 V2 ExpressLRS 2.4ghz Nano Receiver (LBT) The RP2 2.4GHz ELRS nano receiver is an open-source receiver based on ExpressLRS and features ESP8285 MCU and SX1280 RF chip. The RP2 has a built-in ceramic antenna which is super light and small in size and ideal for racing. It has built-in WIFI and is suitable for many models due to the ultra-light and Nano size. Note: Available with standard ISM or EU LBT FW. EU LBT FW is required for use with Radios and Modules with EU LBT FW Installed. Features: - Improved PCB design is better for heat dissipation. - LED on the top side of the PCB. - Solder pads are improved and easier to solder to. - Built-in a TCXO (temperature-compensated crystal oscillator) Specification: Item: RP2 Nano ExpressLRS 2.4ghz Receiver Type: EU LBT FW MCU: EPS8285 RF Chip: SEMTECH SX1281 Telemetry RF power: 10mW Antenna: On Board SMT Antenna Antenna: 65mm 2.4ghz T Antenna Frequency Range: 2.404 - 2.479 Ghz Maximum receive refresh rate: 500Hz/F1000Hz Minimum receiver refresh rate: 25Hz Working voltage: 5v Weight: 0.55g (On Board antenna) Dimension: 13x11x7mm Firmware Version: ExpressLRS v2.4 pre-installed FW Target: RadioMaster RP1/2 2400 RX Bus interface: CRSF
Additional parameters
Category: | Drone Receivers |
---|---|
Protocol: | ELRS2.4 |
The item has been sold out… |
Be the first who will post an article to this item!
Add a comment