-1.png)
.jpeg)
Stack iFlight BLITZ F7 E55S 4-IN-1 +BLITZ 1.6W VTX Flight Tower System
Code: BF15190Product detailed description
BLITZ F7 E55S 4-IN-1 +BLITZ 1.6W VTX Flight Tower System This stack includes BLITZ F7 V1.2 Flight controller with ICM42688, BLITZ E55S 4-IN-1 ESC, and BLITZ 1.6W VTX. FC Specifications: Mounting Pattern: 30.5*30.5mm / 4mm PCB hole diameter Model: BLITZ F722 V1.2 FLIGHT CONTROLLER SmartAudio / IRC Tramp VTX protocol supported Firmware target: IFRC-IFLIGHT_BLITZ_F722 Motor outputs: 4x (SH1.0 connector) Flash: 32MB (Blackbox flash) I2C serial: SDA / SLA pads Dimensions: 36.5*35 mm OSD Chip: AT7456E Barometer: DPS310 MCU: STM32 F722 LED controller: Yes Beeper pad: Yes Gyro: ICM42688 Weight: 7.8g UARTS: 6 BEC: 5V 2.5A / 9V 2A Wiring Suggestion: UART 1 for VTX HD / Analog UART 2 for a Receiver UART 3/4/5 for GPS or other sensors that require a serial port UART 6 for ESC Telemet ESC Specifications: Mounting Holes: 30.5*30.5mm/Φ4mm Weight: 14.7g Supports 2-6S lipo input MCU: BB21 Constant: 55 Amps Burst: 65 Amps Current sensor: Yes BEC: No Current rate: 200 Supports: DShot DShot150/300/600/MultiShot/ OneShot etc. Target: Q-H-25 16.7(BlheliS) / Bluejay Q-H-25 (Bluejay) VTX Specifications: Input voltage: 7V-34V Interface: MMCX Power levels: PIT/25mW/400mW/800mW/1600mW Channels: 40 (including Raceband) Mounting pattern: 30.5x30.5mm/Φ3 Lightweight: 18.9g (excluding antenna) VTX telemetry: IRC Tramp Betaflight IRC Tramp Configuration: Please download the attached VTX table for Betaflight! RC Tramp VTX table values: 25mW/400mW/800mW/1600mW Package Includes: 1 x BLITZ F7 V1.2 Flight Controller 1 x BLITZ E55S 4-IN-1 2-6S ESC 1 x Power cables & ESC signal wires 1 x BLITZ 1.6W VTX
Additional parameters
| Category: | Stacks |
|---|---|
| Mounting Size: | 30.5x30.5mm |
| Power Supply: | 2-6S |
| Continuous Current: | 55A |
| Processor Type: | F7 |
Be the first who will post an article to this item!
Add a comment